Einleitung
Anhand dieser Anleitung kannst du die beiden Schrauben, mit denen das iPhone XR Display befestigt ist, entfernen oder ersetzen. Dies sind die einzigen Schrauben auf der Außenseite des iPhones. Das 5 Punkte Design hat Apple selbst erfunden, deshalb brauchst du einen speziellen P2 Pentalobe Schraubendreher, um sie herauszudrehen.
Werkzeuge
-
-
Schalte dein iPhone aus, bevor du anfängst.
-
Entferne die beiden 6,7 mm langen Pentalobe Schrauben an der Unterkante des iPhones.
-
Abschluss
Um dein Gerät wieder zusammenzubauen, folge dieser Anleitung in umgekehrter Reihenfolge.
One of my gaskets was as shown in your second photo, the other had been worked into the threads (as if smeared) probably from the factory and was completely unusable.
In place of replacements (unsure of where to purchase) I just used a clear silicone caulking on both screws upon reassembly to offer at least some water seal. I wish these gaskets were included with the gasket waterproofing sealant kit!
Erica -
Is there any place to buy these screw gaskets? I haven’t seen it mentioned anywhere but one of mine was pretty much chewed up. Silicone should work but I’d prefer the oem solution.
Chilinh Nguyen -
I found a place on Amazon that sells them. It's cheapest to get a full set of screws than to get just these. $5-$6 USD.
J Olin -