Valve Index Headset Eye Tube Gasket Replacement

Geschrieben von: Sam Omiotek

Kommentare: 1

Valve Index Headset Eye Tube Gasket Replacement

Schwierigkeitsgrad

Moderate

Schritte

Zeitaufwand

15 - 30 Minuten

Einleitung

Follow this guide to remove the eye tube gasket for repairs or replacement on the Valve Index VR headset.

Power off and unplug your Index before you begin your repair.

Werkzeuge

Schritt 1

Insert the flat end of a spudger in between the bottom of the head strap clip and the head strap padding.
Pry up on the head strap clip until it is unclipped from the head strap.
To reinstall, first locate the recesses on the head strap for mounting the clip. Next, align the clip with the recesses, verify the tether cable is threaded through the clip, then simply press the clip back into place.

Schritt 2

Use your hand to gently pull the face gasket straight off of the headset.
The face gasket is held in place by four magnets that secure to screws in the face bezel.
Before installing a face gasket, ensure the four screws securing the face gasket bezel are installed. Otherwise, the face gasket will not stay in place.

Schritt 3

Use your fingers to pull the tether cable straight up off of the head strap cable guide.

Schritt 4

Pull the tether cable straight back out of the headset.

Schritt 5

Use a T5 Torx screwdriver to remove the four 6.0 mm screws securing the face gasket bezel to the headset.

Schritt 6

Do not try and pry the face gasket bezel off, or you will damage the headset.
Grab the left edge of the face gasket bezel with your hand and slide it off of the headset.
During reassembly, visually verify the clips on the face gasket bezel are aligned with the headset before sliding it into place.

Please make sure the nose section slides in properly. [br]

Theres a connector in between the top 2 screws of the gasket that will not make a proper connection if the nose is not aligned.[br]

For me this lead to an array of display output errors.

Leocracy -

Schritt 7

Repeat the previous step for the right side of the face gasket bezel.
Remove the face gasket bezel.

Schritt 8

Use a pair of tweezers to separate the left edge of the eye tube gasket from the headset.
Repeat the process for the right edge of the gasket.
During reassembly, make sure these holes are secured to the pegs on the headset before continuing.

Schritt 9

Gently peel the eye tube gasket out of the headset.
The eye tube gasket is lightly adhered to the perimeter of the lenses. It should pull off easily.

Abschluss

Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.

To reassemble your device, follow the above steps in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Valve Index Answers community for help.