Shark Rocket Zero-M Belt Replacement

Geschrieben von: Nadia Martinez

Kommentare: 0

Schwierigkeitsgrad

Moderate

Schritte

Zeitaufwand

15 - 20 Minuten

Einleitung

This guide is intended to show how to access, remove, and replace the belt on a Shark Rocket Stick Vacuum with Self-Cleaning Brushroll. This replacement may be necessary if the brush roller is turning slowly or not at all.

Werkzeuge

Schritt 1

Flip the vacuum on its right side.

Schritt 2

Turn the T10 Security Bit screwdriver counterclockwise to remove the 15mm screw.

Schritt 3

Turn the vacuum face down.
Turn the T10 Security Bit screwdriver counterclockwise to remove the 15mm screw.

Schritt 4

Use a spudger to pry the side of the vacuum open.

Schritt 5

Use a spudger to pry the old belt away from the two gears.
The new belt will be tight and difficult to put back on. In order to reinstall, place the belt on the brushroll, then rotate the brushroll a couple rotations to make sure the belt is aligned correctly.