Olympus D590 Backplate Replacement

Geschrieben von: Katie
  • Kommentare: 0
Olympus D590 Backplate Replacement

Schwierigkeitsgrad

Easy

Schritte

11

Zeitaufwand

5 - 10 Minuten

Einleitung

The guide shows how to remove the backplate of the camera. It is a prerequisite to other guides such as replacing the mic, speaker, LCD screen, and lens.

  1. tLRBDCXKkV3QFXxf

    • Flip camera so you are looking at the bottom.

    • Unscrew all 5 base plate screws.

  2. xviXHOyDMDQNLxqv

    • Lift open retainer clip by sliding the clip to the left and letting the clip pop up.

  3. HbI3KlmFdDtXiqWg

    • Unscrew the single screw located next to the battery slot.

  4. w6ZLPFeFtDTHba5h

    • Turn the camera so that the USB, AV and DC in/out rubber plate it facing you.

    • Lift the rubber plate exposing the ports beneath.

  5. lWpwRWBLQLbGXt4r

    • Unscrew the 2 screws next to the USB and AC ports.

  6. TrqgK4nV5sZBYJOi

    • Use a flathead screwdriver or another flat opening tool to pry the faceplate from the whole device.

  7. cCr4mQVeNcIX6Qbl

    • Pull off the faceplate to reveal the inside of the camera.

    • Be careful of the connector that goes from the faceplate to the motherboard . Disconnecting this line will cause the camera not not power on through the on/off switch anymore.

  8. gXadTuISO4Ip5tCs

    • Use a phillips head screwdriver to remove the 3 screws highlighted in the picture.

  9. XuRTfqUm1vjZUsPV

    • Unscrew the 2 screws located on either side of the flash.

  10. TV1ai5PFgvDeLk1o

    • Get a flathead screwdriver or an iPod opening tool (both are shown in this picture).

    • Carefully pry off the blackplate from the remaining part of the camera.

  11. jC2x6tq5GgtqOGVT

    • Pull the backplate off.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Katie

Mitglied seit: 15/04/10

31 Reputation

0 Kommentare