Nikon D7100 Motherboard Replacement

Geschrieben von: Alexander DiMartino

Kommentare: 10

Schwierigkeitsgrad

Very difficult

Schritte

Zeitaufwand

1 - 6 Stunden

Einleitung

Werkzeuge

Schritt 1

Remove the five screws on the bottom of the camera with a JIS #000 head screwdriver.

Schritt 2

Remove the 3 screws under the battery flap and remove the bottom cover.

Schritt 3

Remove the 2 screws inside the camera on the back corners.

Schritt 4

Open the HDMI flap and remove the 2 screws.

Schritt 5

Remove the screw next to the camera strap loop.

Schritt 6

Remove the 2 screws on each side of the view finder.

Schritt 7

Remove the 2 screws above and below the SD card flap.

becareful,might lose thread your screw.

Yu Yu - 15/10/20

the two screws under the car door turn very hard (D7200). I affixed a 25mm plastic (delrin) wheel on my JIS 00 + screwdriver for better torque. This worked.

Bernard Delley -

Step 7 might be skipped, if you just need to get at the LCD screen. This side panel with the car slits only supports the lower screw for the back panel in step 8. The back panel might lift off in step 10, without removing the side panel of step 7. If step 10 does not lift off, do step 7 preceding step 10.

Bernard Delley -

Schritt 8

Peel off the adhesive leather screw cover and remove the 2 screws under it.

Schritt 9

Remove the Diopter adjustment control sticker and remove the screw under it.

If you skipped step 7, you have to loosen the 4 step 7 screws by about 1mm to get the back panel off cleanly in the next step.

Bernard Delley -

Schritt 10

Separate the back panel of the camera from the actual camera.
Be careful not to tear any of the ribbon cables.

Schritt 11

Disconnect the LCD ribbon cables and power cable from the motherboard.

Flip up the dark grey tab on the ribbon cable connector with your fingernail to release the clamp before removal. When reassembling ensure the cable is fully reinserted then push the tab back down to lock.

Stephen Lipiec - 19/03/20

Schritt 12

Unscrew all 16 screws around the back plate of the camera.

Schritt 13

Then unscrew the remaining screws holding the back plate to the LCD.
Then simply remove the plate with the LCD.

Are all the screws the same length / size ? Thanks

trevee359 - 22/11/18

Disassembling the D7200, the screen is glued to the frame but it can be carefully prised off using dentist’s hook, make sure you scrape of any old screen glass around the edge.

a.brown.1 - 15/09/19

When starting disassembly group each set of removed screws from each disassembly section and GROUP them, put an earbud cleaner or similar inbetween each group of screws to seperate them as you progress through the disassembly. Then you can work back in reverse when you have installed the new LCD screen. Remember to use a dust blower to remove flakes of the old LCD after installing the new LCD before starting to put the screws back.

a.brown.1 - 15/09/19