Einleitung
If the trigger of the Milwaukee Hackzall 2625-20 is no longer functioning, the following steps will help replace the trigger assembly. The use of a soldering iron is required to remove wiring around the trigger so soldering skills and knowledge are needed. Refer to this guide for more information.
-
-
Remove the screws holding the shell of the device together. Each screw size varies; you will use a T9 Torx screwdriver for one size 7.0 mm.
-
Use a T10 Torx screwdriver to remove one 14.0 mm screw.
-
Use a T15 Torx screwdriver for the remaining eight screws that are 16.0 mm.
-
Remove the casing to reveal all of the internal components.
-
-
-
Use a soldering iron to melt the existing solder that is attached to the back end of the trigger.
-
To reassemble your device, follow these instructions in reverse order.
