Huawei Watch GT 2 (46 mm) Motherboard & Daughterboard Replacement

Before starting repairs, take your watch off the charger and power it down.

Remove the watch band.

Remove the four 3.7 mm-long Torx T2 screws.

Insert the edge of a spudger into the middle loudspeaker opening at the top edge of your watch.

Use the spudger to pry up the back cover assembly of your Huawei watch GT 2.

Carefully swing the back cover assembly open to an upward position.

Remove the two 2.3 mm-long Phillips #00 screws.

Use a pair of tweezer to remove the metal shield covering the multi-purpose flex connector.

Use the flat end of a spudger to pry up and disconnect the multi-purpose flex connector.

Separate the back cover assembly from the watch case.

Use the flat end of a spudger to pry up and disconnect the main flex cable from the daughterboard.

Use the flat end of a spudger to pry up and disconnect the watch buttons flex cable from the daughterboard.

Use the flat end of a spudger to lift the right edge of the daughterboard off its socket.

Use a pair of tweezers to remove the daughterboard.

Remove the three 2.3 mm-long Phillips #00 screws.

Use a pair of tweezers to remove the metal shield covering the display connectors.

Use the flat end of a spudger to pry up and disconnect the left display flex cable.

Use the flat end of a spudger to pry up and disconnect the right display flex cable.

Use a pair of tweezers to carefully peel the watch button flex cable off the motherboard and fold it to the side.

Remove the motherboard.