Hover-1 XLS Battery Replacement

Geschrieben von: Jonathan Hidalgo
  • Kommentare: 1
Hover-1 XLS Battery Replacement

Schwierigkeitsgrad

Moderate

Schritte

2

Zeitaufwand

5 - 10 Minuten

Einleitung

If the bike is not performing at its maximum capability, its battery may be corroded, and you should replace it as soon as possible. Before beginning this guide, you will need power tools or a chemical remover to deal with Teflon tape on the screws.

  1. UZsemWZZY2FOVMLr
    UZsemWZZY2FOVMLr
    s3WxGhyYbSUch3Tv
    qGCqs4aHTDbCegsB

    • Remove the four, 12mm Hex #3 screws located on the bottom half of the battery compartment.

    • There are four screws that need to remove. Two on one side and the two on the opposite side.

  2. JSb6AdcrFKVIt1Ab
    JSb6AdcrFKVIt1Ab
    PmrZOnKQF2lETsGU
    FkyKgYDiwJZpS24j

    • Remove the adhesive holding the wires tightly.

    • You can use a sharp object to score the adhesive before pulling.

    • Pull on both sides of the wire connections.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Jonathan Hidalgo

Mitglied seit: 24/01/19

557 Reputation

Ein Kommentar

That looks easy enough to do. My problem is finding a replacement battery. Do you have any idea where they are available?

David Schultze -