Harman Kardon Onyx Studio 2 Akku austauschen

Geschrieben von: Alexandra Achtenberg
  • Kommentare: 25
Harman Kardon Onyx Studio 2 Akku austauschen

Schwierigkeitsgrad

Einfach

Schritte

5

Zeitaufwand

10 - 15 Minuten

Einleitung

Du musst zuerst die vordere Abdeckung abnehmen, um an den Akku zu gelangen.

  1. dBMtxPy1K1rUnFpu
    dBMtxPy1K1rUnFpu
    iQOTA3V6DRt2d21M
    dQ2kJq1EW24lJYMB

    • Setze ein Plastiköffnungswerkzeug in die Vertiefung an der Vorderseite des Gerätes ein und heble das Lautsprechergitter ab.

    Where can I find a new front panel for my speaker

    consomme69 -

    If I take this off can I put it back on

    Burger King -

  2. o5SWK6TwGvJXXZkQ
    o5SWK6TwGvJXXZkQ
    jqcCAC2kkM2JaaRl

    • Entferne fünf 14,4 mm Torx T10 Schrauben.

    There are NO torxscrews. You have to pull out the rubber grille grips that are inside the screw holes FIRST, then use a regular sized Phillips head screwdriver to remove the cover. No Torxscrewdiver needed. I found this out after I had already purchased one from you guys.

    phillip columbus -

  3. aLaClpNCSQVOuCfs

    • Ziehe die Vorderseite vorsichtig von der Rückseite ab.

  4. 1SWuvDl2qU1UaEUc
    1SWuvDl2qU1UaEUc
    yCr1XiiAOCKacJsD

    • Löse die vier Verbindungskabel von Virder- und Rückseite.

    • Drücke die Klinke am Stecker ein und ziehe ihn ab.

    • Wiederhole für die anderen drei Stecker.

  5. HoCr3OpphLskQEVZ
    HoCr3OpphLskQEVZ
    Sl4yxYIZDYha33Gr
    aNCOEaN6n3i2Dhve

    • Entferne drei 10,4 mm Torx T10 Schrauben von der Akkuabdeckung.

    • Entferne die Akkuabdeckung.

    • Ziehe den Akku heraus und ersetze ihn.

    What battery is the replacement? Are there one or two batteries inside? Could have been a good “how to instruction” but left out some important facts. Duh?

    David Forster -

    You should include that the battery compartment is in the BACK.

    Also, there are two compartments in the back. I tried to open the wrong one.

    My torx socket didn't fit into the central hole of that compartment. Arrrgh! So I used a drill to make the hole bigger, only to find upon opening that it was the wrong compartment.

    The correct one was easier to open. (!) I found I needed to wrap part of the new battery in electrical tape to avoid it rattling around.

    Putting it all back together had two challenges. There's a very thin rubber gasket that has to be delicately pressed back into its channel. Also, the larger rubber surround has to be placed appropriately on the various buttons (power, volume, Bluetooth).

    I'd rate this as “medium" difficulty.

    Craig Cunningham -

    BTW, the correct replacement for the single battery is easily found online by searching “replacement battery Harman Kardon Onyx Studio”. (Student One and Two use the same battery.)

    Craig Cunningham -

    Super

    merci Infiniment pour ce tutoriel

    Olivier Decoopman -

Abschluss

Um dein Gerät wieder zusammenbauen, folge den Schritten in umgekehrter Reihenfolge.

Tinte & Feder

Alexandra Achtenberg

Mitglied seit: 02/02/17

1771 Reputation

18 Kommentare

Thanks for the step by step instructions. I have tried replacing the batteries but the speaker still won't turned on. I believe the battery cable/module is broken, do you know how to fix it? Thanks.

Wompy Pratomo -

Can you put a step by step instruction how to replace a battery on a Harman/ Kardon esquire 2?

Bullet Magnet -

Hello, what kind of battery is good for replacement? I'm thinking of using LG 3000mAh or Panasonic 3400 mAh (both unprotected) and making a direct swap. Help please

marcel -

Can you tell me what kind of the hk onyx speaker battery's, if you can show me step instructions to replace! Thankyou!

happymandm8 -

This worked great. Thanks. Battery would not charge. Bought a replacement on Ebay and now it works as if new.

JSM -

Hello,

Where I can buy those 14.4 mm T10 Torx screws online?

Levan Rozomashvili -

Hello

What is the battery for the Harman Kardon Esquire 2 speaker?

Regards

Isaac Moura -

Pls where can I get a battery?

Emmanuel -

My onyx is onyx studio

Emmanuel -

Here is where you can find a good battery. https://www.ebay.com/itm/192530902153

tkuan -

What if the wires connected to the battery were splice for another battery hook up .and a wire on the battery broke and my charging ports are no good what can i do

Karlos milliar -

Is it possible to use just the power supply

Carbon cookie -

Anyone know the model of the 3-pin connector on the battery?

Sagar -

The battery of onix 2 could work to Harman kardon onix 1?

orlandinez -

Buen día, necesito orientación respecto a una HK onyx studio 3, no logro conseguir la batería, sería el mismo modelo que el que sugieren aquí?

gio ram -

Thanks for the easy replacement instructions. Our school bought 4 of the 1st generation HK Onyx speakers and all 4 batteries bit the dust this year. It was a breeze to find better replacements than the original on Amazon and Ebay and these instructions gave me the confidence to disassemble, replace, and reassemble the speakers. Everybody thinks I’m a genius. Thanks again.

Bobby Hirschhorn -

Can i take the speaker into you store for battery replacement

ronh8211 -

can anyone tell me if thare is an instruction on how to open an H/K onyx studio 1.

It looks a litle bit the same but thare are no screws in the hole's

Ewin -