Einleitung
Ersatzteile
-
-
Press both thumbs on each side of the upper corners, and apply pressure in a downward motion.
-
While applying pressure, slide the back cover down.
-
-
-
Remove the four 6 mm T5 Torx screws from the four corners on the back of the phone.
-
Remove the two 4 mm T5 Torx screws from the middle of the back of the phone.
-
-
-
Insert a spudger into the slit between the frame and cover, and push downward to dislodge the back plate from the phone.
-
Use the spudger to go around the edges of the phone to further dislodge the back plate.
-
-
-
Remove the 3 mm Phillips screw located on the side of the bottom left-hand corner of the phone.
-
Remove the 3 mm Phillips screw located on the top right-hand corner of the phone.
-
-
-
Place a finger between the circuit board and front cover, and lift up gently.
-
Separate the circuit board from the front cover and screen to detach the ribbon cable holding them together.
-
Finish separating the circuit board from the front panel.
-
-
-
After following the prerequisite guide listed above, the phone should have the circuit board housing group on one piece.
-
The front cover and screen of the phone should be located on the other piece.
-
-
-
Place a finger on the front side of the screen, and push up as indicated.
-
Carefully grab onto the sides of the LCD and glass screen.
-
Continue to angle the LCD and glass screen further up.
-
-
-
Carefully lift the screen away from the front cover.
-
The adhesive should be easy to separate while separating the front cover from the screen.
-
To reassemble your device, follow these instructions in reverse order.
