Einleitung
This guide gives step-by-step instructions for removing the outer shell of the base to assess the logic board within the phone. After completing this guide, you will have access to the logic board and all other interior parts of the telephone.
Werkzeuge
Ersatzteile
-
-
Using a plastic opening tool, remove the phone cord from the phone jack from the base of the headset.
-
To release the cable gently, press down on the top plastic tab of the connector.
-
-
-
Remove the phone cord screw cap.
-
Unscrew the 7.5mm screw.
-
Remove the screw cap.
-
Pull up the phone cord to remove from the base.
-
-
-
Locate the volume dial on the right side of the telephone.
-
Remove the volume dial by gently grasping the dial and pulling away from the base.
-
-
-
Remove the six screws from the base shell located on the back of the device.
-
Remove the three 12mm screws with the Philips head #1 screw driver.
-
Remove the three 18mm screws with the Philips head #1 screw driver.
-
-
-
Pry off the base shell using a plastic opener tool.
-
Set shell aside and you now have access to the internal components of the General Electric Telephone 2-9710A.
-
Reassemble your devise by following these instructions in reverse order.
