ATT CL2940 Speakerphone Replacement

Geschrieben von: Charles Messmore
  • Kommentare: 1
ATT CL2940 Speakerphone Replacement

Schwierigkeitsgrad

Moderate

Schritte

6

Zeitaufwand

30 - 40 Minuten

Einleitung

A speakerphone is used to talk hands-free on the phone. This guide will educate you on how to replace one if it is part of your ATT CL2940.

You will need to solder to complete this guide. If you are not familiar, check out this article for an introduction.

  1. TkrvmhM5T2HRKSb5
    TkrvmhM5T2HRKSb5
    A5nSAkjP2NfHs4yK
    xhVxGOoEkjWjiOww

    • Remove five 9.5 mm Phillips #1 screws from the back panel of the phone.

  2. UFGjamdGKS2tX5Lb
    UFGjamdGKS2tX5Lb
    JxFg3uZ1beBdoQDk
    X2ZPG1feZ2dZeUfs

    • Slide the metal spudger into the crack and continue around to the front panel of the phone.

    • Be careful not to break the clips that hold the back panel to the front panel.

  3. UPJdLAAOFnWjEROa

    • When setting the back panel down, be careful to not rip any of the wires off of the internal components.

  4. ZxKYpROHTK3WHW6n
    ZxKYpROHTK3WHW6n
    TYFWbdRRp5B4tni3

    • Remove the front panel of the device as shown.

  5. ln1dHLH4DlVQIS4A
    ln1dHLH4DlVQIS4A
    dfTMPqIw6EZOBIsY
    1wCvNLWIqlk4kMQf

    • Desolder the speakerphone with a soldering iron.

    • If you are unfamiliar with solder, check out the article on soldering and be very careful. The iron is hot!

  6. MUFXNlLbmdOAwt5F
    MUFXNlLbmdOAwt5F
    jRnTy16wWDqr1LBX

    • Use the soldering iron to reconnect the wires to the new speaker.

    • Place the new speaker back in place.

    • Make sure that all of the components are back in place.

Tinte & Feder

Charles Messmore

Mitglied seit: 15/02/16

541 Reputation

Ein Kommentar

Why do all these repairs require NO PARTS to replace defective parts?

And, of course< there is no links to a place to purchase the needed parts...

rpoland -